| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| BobCad-Cam Discuss all BobCad software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
06-17-2005, 01:37 PM
| ||||
| ||||
| Yes, there is a setting you can make in the "conversion" window in the nc setup. I remember discussing this on their forums years ago. You should register over there and do a forum search on the topic. What it boils down to, is you can kill off all K words by putting this expression in the "original" window: K-*[0-9]*.[0-9]* and leave the corresponding line in the "convert to" window blank.
__________________ First you get good, then you get fast. Then grouchiness sets in. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DNC with parallel port (Bridgeport BOSS 5)? | hobbymat | General CAM Discussion | 3 | 07-20-2009 11:16 AM |
| Boss 5 60006 Error? | ROB-WA | Machine Problems, Solutions , Wireless DNC, serial port | 2 | 08-18-2005 01:52 AM |
| Need so Bridgeport Boss education. | AAA | Bridgeport and Hardinge Mills | 10 | 08-01-2005 07:39 PM |
| Bridgeport Boss Retrofit help | moto21 | Bridgeport and Hardinge Mills | 7 | 06-09-2005 10:32 PM |
| Boss 5 help needed | rsr911 | Bridgeport and Hardinge Mills | 4 | 10-27-2004 12:10 AM |
| | |
Linear Mode
