View RSS Feed

All Blog Entries

  1. 2001 40-20 fadal spindle speed drop to min in or out of cut at random.

    by , 05-06-2013 at 12:26 PM
    Spindle will drop from programed speed to minimum speed at any time, in or out of cut high or low range, the active speed does not change on the screen, axis feed rate does not change. No error code is recorded. Service guy was here last Thursday, as you might guess it wouldn't fail for him. Anyone had this happen?
    Categories
    Uncategorized
  2. programming

    by , 05-05-2013 at 12:38 PM
    Hello All,
    New to the forum and had just a general question of dealing with a difficult environment. Recently hired on as lead programmer at a medium sized shop that does a lot of 1 or 2 part runs, usually multiple setups. The method they seem to use to prove a program is to push the green button and walk away. If it doesn't throw an alarm on the machine screen it is assumed to be ok. No dry run, no single blocking, no real checking of any kind. We don't have and won't be getting any ...
    Categories
    Uncategorized
  3. New RaptorXZ

    by , 04-29-2013 at 11:03 PM

    RaptorXZ

    30X36 25x30 Travel
    30X48 25x42 Travel
    20mm Profile rails
    3/4 Inch aluminum frame
    Y 1610
    X 2510
    8 inch Z axis
    12 inch optional Z axis
    www.x0cnc.com

    Updated 05-27-2013 at 01:03 AM by CNCadmin

    Categories
    Businesses
Page 5 of 5 FirstFirst ... 2345


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.