| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Benchtop Machines Discuss all mini mills sherline, taig, square column, round column and CNC mill conversions here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-09-2009, 07:29 PM
| |||
| |||
ok i have a large benchtop cnc setup with g201 and some really old round 400oz nema 34 steppers at 24v but i keep having drives go out on my x axis!!! i find it sad when i get all of about 4 wax parts out of it a drive dies i think its a bad motor but they all ohm the same so idk i have been thinking about doing servo motors instead of steppers but have no idea what a person has to do to set that up! my machine does run ball screws and i am running mach 3 any help would be grate thanks!!    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Whats the difference????? | endmill1 | Controller Cards | 1 | 03-21-2009 12:10 PM |
| whats the difference between servo and stepper controllers? | Hodges_Guitars | Controller Cards | 1 | 07-11-2008 08:59 PM |
| whats new? | single phase | Hypermill | 2 | 08-02-2007 03:24 PM |
| Whats it for? | bearwen | DIY-CNC Router Table Machines | 1 | 03-09-2006 03:46 PM |
| | |
Linear Mode
