| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Benchtop Machines Discuss all mini mills sherline, taig, square column, round column and CNC mill conversions here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-12-2009, 08:09 AM
| |||
| |||
Hey folks, The spindle motor on my X1 is hunting up and down. It'll truck along for a while at a consistent speed, then wander up and down for a bit. It's almost like one of the adjustment pots is bad, or perhaps the main pot. Any suggestions before I start digging into the drive electronics? D.    |
|
#2
05-13-2009, 06:45 PM
| |||
| |||
| Hi, Not quite the same but I had a similar problem here Speed controller problems, your help please. . Not sure if it will help but might.  Good luck, John |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Coming Down to the Taig Micro Mill or Grizzly Mini Mill. | SpeedsCustom | Taig Mills & Lathes | 15 | 01-23-2009 12:14 AM |
| Taig micro-lathe max spindle speed | rfrenzl | Taig Mills & Lathes | 2 | 08-01-2008 01:19 PM |
| Micro torque converter to slow router speed | technomage | DIY-CNC Router Table Machines | 1 | 10-17-2007 10:52 PM |
| Need Help - Machine Hunting! | Hukfinn77 | Machines running Mach Software | 0 | 05-04-2006 02:00 AM |
| Need help with a HF micro-mill | mondo50 | Benchtop Machines | 3 | 08-26-2005 10:52 AM |
| | |
Linear Mode
