| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Benchtop Machines Discuss all mini mills sherline, taig, square column, round column and CNC mill conversions here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#25
 
05-11-2009, 11:41 PM
| ||||
| ||||
| The 325 is only 80" inches tall, it should fit in any garage with ease.
__________________ Patience and perseverance have a magical effect before which difficulties disappear and obstacles vanish.  |
| Sponsored Links |
| |
|
#26
05-12-2009, 06:39 AM
| |||
| |||
I only got the Cinci because it was such a smokin' deal, otherwise the RF was working fine for me. Incidentally I found this from the download plugins section on machsupport.com. http://www.vitalsystem.com/web/motion/dspmc.php I believe VMC servo drives require a -10v - +10v signal rather than the step/dir Mach and EMC put out. This device may "bridge the gap" allowing a relatively easy Mach controller retrofit. Could be interesting as typical controller upgrades cost around $15K. Joe |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| RF45 CNC with servos on eBay | scudzuki | Benchtop Machines | 6 | 05-07-2009 11:05 PM |
| Noticed a Bigger RF45 option | davo727 | Benchtop Machines | 4 | 12-12-2008 04:49 PM |
| RF45 clone with a DC motor | hdj80 | Industrial Hobbies (Support forum) | 5 | 05-29-2007 05:01 AM |
| X3 or RF45 clone? | logjammer | Benchtop Machines | 13 | 12-14-2006 08:34 AM |
| At China buy RF45 only USD 812 | szcharle | Knee Vertical Mills | 17 | 11-17-2006 06:09 PM |
| | |
Linear Mode
