Littlemachineshop has what your looking for , their a advertiser here, so tell then where you found them- http://www.littlemachineshop.com/inf...iniMill_04.htm
Hi All,
I finished adding some 120 oz steppers to my Grizzly
mini mill, and I have tested it on wood by just using the drill chuck to hold some endmills.
Great.
Now I need a bit of shopping advice on what I need to buy to hold various tools from 1/8" to 5/8" diameters.
Can the two grizzly provided collets be used with adapter for the small tools, or do I get a set of them, one for each shaft size?
I'm just a tad undereducated on this collet stuff.
Is there a nice 'starter kit' I can get for tool holders?
Help!
-Les
Littlemachineshop has what your looking for , their a advertiser here, so tell then where you found them- http://www.littlemachineshop.com/inf...iniMill_04.htm
Thank You,
Paul G
Site Owner-Webmaster-
Administrator
www.rfqwork.com
www.cnczone.com
www.welderzone.com
Thanks for the link!
I have some work I'd like to do with small 'dremel' sized bits, but I now realize that I can't get the needed spindle speeds for these with the mini-mill spindle. I need to figure a way to attach a small fast spindle to the mini mill spindle housing. I only need to cut a 2" by 2" with the tiny tools. Maybe a dremel with a 90 degree adapter, if they make one?
-Les