tooling for 10 X 22 lathe

[mcundiff1]

Hey all;

I was going to be getting a Grizzly G0602 10 X 22 Lathe in May. I was wondering if I can use 1/2" shank tooling in a AXA QCTP and be on center. I could not on my 7 X 14. Tools fit holder , but where not on center. They bottomed out on compound. I wish to use insert tooling.


Thanks Mitch ..................

[hoss2006]

I'm sure it can, I have an AXA on mine. i'll take a pic later to show how much room is there.
Hoss

[hoss2006]

Here ya go.
A 1/2 tool in an AXA 1 tool holder sitting flush on the compound lines up perfectly with the center.
they must have planned that or something.
Hoss

[mcundiff1]

Thanks For Info...


Mitch ............