SHERLINE rotary table - CNCzone.com-The Largest Machinist Community on the net!

ACME · #1 10-25-2004, 03:43 AM

hello,
anyone know what is a TPI no. for Sherline rotary table?

or

what is a .INI No. for Turbocnc(Sherline rotary table)?
1)Step per rev:_
2)Pitch of screw:_
3)Microstepping:_
4)Reduction:_

thanks

fpworks · #2 11-16-2004, 10:15 PM

here's a small piece for your puzzle:

1 revolution of input shaft = 5 degrees on the table

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Advise needed for rotary table conversion	spoiledbrat	DIY-CNC Router Table Machines	2	05-11-2005 02:34 PM
Build a CNC rotary table? (longish)	jcolley	Mechanical Calculations/Engineering Design	0	02-12-2005 08:23 AM
rotary table chuck	senor J.	General Metalwork Discussion	2	12-15-2004 03:21 AM
5th even 6th axis? how does it work	ToMMY2ooo	General Metal Working Machines	10	10-04-2004 03:58 PM
Cross slide work pc on rotary table	replicapro	General Metalwork Discussion	4	07-08-2004 05:30 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)