| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Benchtop Machines Discuss all mini mills sherline, taig, square column, round column and CNC mill conversions here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-16-2008, 12:01 AM
| |||
| |||
| Disassembly of Z leadscrew on x3 Hi, I'm trying to pull the bottom of my lead screw apart for a CNC fusion conversion. I believe I need the bracket and bearings (got the deluxe kit/ballscrews) on the bottom end. I got the top bracket off but am trying to figure out the rest. The lead screw has 2 nuts on it with 4 square cuts at 90* intervals. I'm not sure what I need to take this thing apart and could use some advice before I go any further. Thanks, Adam    |
|
#2
09-16-2008, 10:20 AM
| ||||
| ||||
| The "X3 Preparation Guide" by arc euro in the UK is what you need! http://www.arceurotrade.co.uk/projec...on%20Guide.pdf |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need tips on SX3 disassembly | Involute | Syil Products | 7 | 08-23-2008 02:10 PM |
| X3 Spindle Disassembly | dneisler | Benchtop Machines | 11 | 08-16-2008 04:37 PM |
| SX3 disassembly trouble | Involute | Syil Products | 2 | 04-22-2007 07:16 AM |
| Acme leadscrew or Trapezoid leadscrew is better? | minicnc | DIY-CNC Router Table Machines | 3 | 03-07-2005 12:57 PM |
| disassembly of stepper motors | dhprc2 | General Electronics Discussion | 8 | 06-25-2003 08:09 PM |
| | |
Linear Mode
