| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Benchtop Machines Discuss all mini mills sherline, taig, square column, round column and CNC mill conversions here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-23-2008, 12:34 AM
| |||
| |||
It doesn't seem to be possible to easily control the spindle speed of the standard F120E unlike the high speed version where speed is controlled by a dc voltage. I've been searching the web for a solution to this problem but so far without success! I'm sure that somewhere I've seen a reference to replacing the controller board but can't now find the reference. Alternatively I suppose it would be possible to use the high speed motor board which does use a dc voltage to control the speed. I'd be grateful for any ideas.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Spindle Speed Control for X3 with C11G BOB & Mach3 | MRM RCModels | Benchtop Machines | 24 | 07-26-2008 12:39 PM |
| SX3 spindle speed control with Mach3 | bbox | Benchtop Machines | 47 | 07-05-2008 05:15 PM |
| Problem with manual machining on a WABECO F1210E CNC mill | dynosor | Benchtop Machines | 4 | 06-13-2008 02:06 PM |
| Changing controller/SW on Wabeco F1210E? | sunracer | Benchtop Machines | 2 | 12-11-2006 09:47 PM |
| Wabeco Speed Control | pv_uk | General Electronics Discussion | 3 | 04-16-2006 09:58 AM |
| | |
Linear Mode
