What size DRO scales for SX3? - CNCzone.com-The Largest Machinist Community on the net!

jon003 · #1 05-21-2008, 10:39 AM

I'm looking at the Meister unit on ebay, and it seems a good deal.

I'm not entirely sure what size scales you get for an SX3 though.

RonF · #2 05-22-2008, 07:53 PM

Email them and they will suggest the size. Compare this with your travel.
It should work out well. I have a Meister 3 axis on my X3 Grizzly and it is
absolutely great! I well recommend the product and they have great support.
Regards,

jon003 · #3 05-23-2008, 11:20 AM

Good to know. They suggested 16x14.5x6, but I think I might just go 16x16x6.

RonF · #4 05-23-2008, 06:08 PM

That's what I got. 2 x MS4-40 (15.75 inches) and 1 MS4-15 (5.91 inches)
Cables provided are good quality too. Braid shielding inside flex aluminum casing.
Regards,

jon003 · #5 05-24-2008, 08:10 AM

Originally Posted by RonF

That's what I got. 2 x MS4-40 (15.75 inches) and 1 MS4-15 (5.91 inches)
Cables provided are good quality too. Braid shielding inside flex aluminum casing.
Regards,

Got some install photos?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Dro scales	CNCadmin	Benchtop Machines	2	03-25-2010 03:56 PM
Help with optical scales	edbanks	General Electronics Discussion	3	04-12-2007 03:25 PM
VM-3 Linear Scales?	100	Haas Mills	7	03-05-2007 12:31 AM
Two Scales for Z- Axis?	TZ250	Milltronics	7	09-10-2006 10:56 PM
Dro Scales	CNCadmin	Benchtop Machines	10	08-06-2003 01:03 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)