my sieg x3 cnc enclosure

[tecknobehinde]

Hi All,

Thought I would share a couple of piccys rfom my half finished enclosure I fabricated from steel. It still has polycarbonate screens to go in and there is a shower curtain that covers the back which is more than adequate.

Ill try to post some more as I finish it.

[SpeedsCustom]

Looks nice, I like it. Nice work area.


-Jason

[kawazuki]

Nice to see another Sieg C4 owner But won't the enclosure cramp you for gear changing?

[cjdavis618]

It looks like a good idea, but if I am seeing this right, your Y axis doesn't have enough room to come out. Unless the enclosure slides with the table somehow.

[tecknobehinde]

The Y axis is nearly at its full extent on the picture. Its only got about 4 more inches to go so I did give it plenty of room. The polycarb door will flip up giving easy access, there is plenty of room all round to get your work piece in!.

[cjdavis618]

Good job then. I guess it was the camera angle, but it didn't look like it had enough room.

There for a little bit, I was happy to know I wasn't the only one that did stuff like that.