my sieg x3 cnc enclosure - CNCzone.com-The Largest Machinist Community on the net!

tecknobehinde · #1 04-14-2008, 07:01 AM

Hi All,

Thought I would share a couple of piccys rfom my half finished enclosure I fabricated from steel. It still has polycarbonate screens to go in and there is a shower curtain that covers the back which is more than adequate.

Ill try to post some more as I finish it.

SpeedsCustom · #2 04-14-2008, 08:34 AM

Looks nice, I like it. Nice work area.

-Jason

kawazuki · #3 04-14-2008, 03:27 PM

Nice to see another Sieg C4 owner

But won't the enclosure cramp you for gear changing?

cjdavis618 · #4 04-14-2008, 04:24 PM

It looks like a good idea, but if I am seeing this right, your Y axis doesn't have enough room to come out. Unless the enclosure slides with the table somehow.

tecknobehinde · #5 04-15-2008, 02:32 AM

The Y axis is nearly at its full extent on the picture. Its only got about 4 more inches to go so I did give it plenty of room. The polycarb door will flip up giving easy access, there is plenty of room all round to get your work piece in!.

cjdavis618 · #6 04-16-2008, 12:05 AM

Good job then. I guess it was the camera angle, but it didn't look like it had enough room.

There for a little bit, I was happy to know I wasn't the only one that did stuff like that.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
What to use for an enclosure?	Tim Wiltse	Xylotex	8	10-03-2008 02:36 AM
tl 1 enclosure	fourperf	Haas Lathes	3	02-25-2008 04:56 AM
My new enclosure	David Da Costa	Commercial CNC Wood Routers	3	10-28-2006 12:03 PM
New All In One Enclosure	mlaws1172	General Electronics Discussion	5	10-20-2006 07:26 PM
enclosure	strat	DIY-CNC Router Table Machines	5	02-28-2005 11:12 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)