| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Benchtop Machines Discuss all mini mills sherline, taig, square column, round column and CNC mill conversions here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-05-2007, 11:42 PM
| |||
| |||
I tried to fire up my Rong Fu RF45N2F tonight and failed. I did some troubleshooting and have come to the conclusion that the small transformer located inside of the control panel is defective. I have 120v on the primary side but only 4v on the secondary side. I do not know if this is correct, but I am assuming that the control circuit is either 12v or 24v. Can anybody verify this? Am I on the right track? Any other input? Thanks in advance.  |
|
#2
12-06-2007, 03:40 PM
| ||||
| ||||
| Maybe it's made for 230V? |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rong Fu RF 45 CNC Conversion | JackSmith | Knee Vertical Mills | 15 | 02-06-2011 11:21 AM |
| Rong RF-31 | Hellbringer | Benchtop Machines | 10 | 09-11-2008 02:40 PM |
| Converting Rong-Fu 25 | adryan | Vertical Mill, Lathe Project Log | 45 | 11-14-2007 05:55 PM |
| VFD for Rong Fu 25 | adryan | Phase Converters and VFD | 3 | 01-22-2006 10:07 AM |
| Is this a Rong Fu 45 | JOE65 | Benchtop Machines | 1 | 06-05-2004 09:09 AM |
| | |
Linear Mode
