Another belt drive question

[AGA-man]

Having just stripped one of the gears (On my similar to a X2 machine)I've been looking at different belt drives etc and like the look of the one done by "Fig noggle" has anyone done this if so could they help me out with the pully and belt sizes?
many thanks
steve.

[dang]

Hi,
I'm doing the same thing presently. The gears on my X2 have been stripped twice. I'm sick of ordering the replacement gear, just to have to do it again two months later. It's my fault for always running in high gear.
Long story short, I'm building the small pulley on my lathe presently. I found the prints here. http://www.hossmachine.com/projects_...t%20conversion

Hoss is THE MAN!