newbie to cnc - CNCzone.com-The Largest Machinist Community on the net!

adrobbi · #1 06-07-2007, 11:37 AM

Hi

I am starting a project. I have bought a 3 axis simplestep microstepping driver

One feature of this ( AlienCnc Driver ) is two phase bipolar pulse.. But , I have bought three unipolar stepper motors .. have I bought the wrong kit ???

Any ideas please

hoss2006 · #2 06-07-2007, 02:23 PM

most unipolar motors(6-8 wires)can be wired to use on a bipolar board (4 wires)
Look here, these guys can give you some pointers.

adrobbi · #3 06-08-2007, 02:18 AM

Thanks for your help ..

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Newbie in need of help	Erlock	Mastercam	4	06-06-2007 08:12 AM
cnc# newbie	wim	Parts for Radio Control Models	2	08-24-2006 09:22 AM
Newbie needs help!	Cruciform	G-Code Programing	1	07-17-2006 01:32 PM
Newbie, would like to know...	cloudbase	CNC Wire Foam Cutter Machines	2	04-13-2004 09:10 PM
Hi, Newbie here	elad	CNCzone Club House	6	04-01-2004 10:25 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)