| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Benchtop Machines Discuss all mini mills sherline, taig, square column, round column and CNC mill conversions here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-28-2007, 03:38 PM
| |||
| |||
Hi guys, I have a little question. I'm trying to convert a HBM BF20 large table (just another version of the BF20). I'm using 2,2 or 2,5 Nm motors on the X and Y (both will be 3:1). But what motor should I use for the Z. It will also be ratio of 1:3 or 1:6. I use a standard leadscrew setup. I hope I make sense. I hope I can use a 4 Nm stepper (I know a good supplier fot those). I'm not looking for a speed monster. grtz. Danny van Dijk Rotterdam, Nehterlands, Europe  |
|
#2
04-28-2007, 03:57 PM
| ||||
| ||||
| Did you see this previous post, It looks like someone else from the netherlands. http://www.cnczone.com/forums/showthread.php?t=15538 Maybe something in there may help or PM the Guy. Al.
__________________ CNC, Mechatronics Integration and Machine Design. “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New To Machining-ADVICE NEEDED PLEASE | phyter23 | Benchtop Machines | 4 | 12-09-2006 04:47 PM |
| new-b to cnc zone advice needed please. | peterwrightman | Parts for Radio Control Models | 8 | 08-19-2006 08:31 PM |
| Career advice needed !!! | yupyup4me | General Metalwork Discussion | 35 | 05-25-2006 12:08 PM |
| advice needed | trubleshtr | General Electronics Discussion | 32 | 04-21-2005 08:48 PM |
| Little advice needed | STUG | DIY-CNC Router Table Machines | 1 | 01-25-2005 07:11 PM |
| | |
Linear Mode
