| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Benchtop Machines Discuss all mini mills sherline, taig, square column, round column and CNC mill conversions here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
04-26-2007, 07:30 PM
| |||
| |||
My X2 mini mill motor is cutting out (yellow fault light) at what I feel is too low a load. I know I need to adjust a potentiometer on the control board, but I don't know which one, and can't find a circuit diagram. I see (top to bottom) R3, R29, and R33. Any ideas? Thanks! -Jeff
__________________ www.JeffAlbro.net/cnc/  |
|
#2
04-27-2007, 08:25 AM
| |||
| |||
| Talk to Jim RabidWolf at the 7x12 Yahoo group or contact him through his site www.unclerabid.com Aaron |
|
#3
04-27-2007, 05:42 PM
| |||
| |||
| Thanks Aaron... Richard from Syil America tells me it is "R3". (Thanks Richard!) -Jeff
__________________ www.JeffAlbro.net/cnc/ |
|
#4
05-01-2007, 06:31 AM
| |||
| |||
| i just twiddled around with mine till it ran satisfactorly mike |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mini lathe and mini mill spindle? | ZipSnipe | General Metal Working Machines | 3 | 10-15-2010 08:13 AM |
| Home-Brewed CNC Bench Mill Using Siex X2 Mini-Mill Head | fignoggle | Benchtop Machines | 18 | 05-11-2009 11:11 PM |
| Please help, current limit resistor calculations | scratch_6057 | Open Source Controller Boards | 5 | 01-24-2007 08:49 AM |
| Current limit on controller board | Htthanh | Stepper Motors and Drives | 7 | 08-31-2006 02:43 PM |
| Linistepper & Current Limit Resistors | scratch_6057 | Open Source Controller Boards | 3 | 06-02-2006 02:24 PM |
| | |
Linear Mode
