| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Benchtop Machines Discuss all mini mills sherline, taig, square column, round column and CNC mill conversions here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-23-2004, 06:48 PM
| |||
| |||
for the Grizzly #8689, Micro Mark #82573, Homier #03947, and Harbor Freight #449 models would work well.  |
|
#2
03-24-2004, 03:41 PM
| ||||
| ||||
| I'm not sure what you're asking. Do you want advice on spindle motors or axis drive motors?
__________________ My name is Electric Nachos. Sorry to impose, but I am the ocean. http://www.bryanpryor.com (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#3
03-24-2004, 11:15 PM
| |||
| |||
| If your asking about stepper/servo motors, I suggest 300oz, no less but can do with more, I was running my 300oz motors at 2a instead of 4a and just a little bit of crap on the ballscrew would make it miss some steps. This was around 150-200oz/in now Im running at full bore and it is very good. the spindle drive motor is typically between 4/5 and 3/4hp I think the micro mark is 1/2hp Jon
__________________ CNC Mini Lathe Plans and Rotary Table kits: http://jfettigmachines.com |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
