| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Benchtop Machines Discuss all mini mills sherline, taig, square column, round column and CNC mill conversions here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-16-2007, 11:26 PM
| |||
| |||
| D&M and other School Orphans Howdy I wanted to make a place for anyone that has information/questions concerning the cnc mills that were (are) aimed at the education market Light Machines Enco D@M Benford Rhino Lab Volt Most are older with good iron, but quirks unique to each. I have a Rhino ST6 Lathe - a demonstrator left orphan when Lab Volt took them over. A D@M 6 Mill that was replaced by newer enco stuff. The Lathe is living on the borrowed time of a windows 96 computer with an active search for an xp based control. The D@M is in the process of getting "modernized" with help from Conqueror Design and Engineering Limited http://www.eaziform.co.uk/phpwcms/index.php?welcome in the form of an internal controller card and updated control software. Well - good luck on your cnc adventures    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Old School Calibration | kenbarra | Calibration & Measurement | 4 | 04-30-2007 08:16 AM |
| New cnc school | warnercnc | CNCzone Club House | 1 | 02-19-2007 11:25 PM |
| School in Socal? | Do.kevin | Employment Opportunity | 0 | 01-18-2007 02:12 PM |
| School Project | Strider2006 | Mastercam | 1 | 12-09-2006 06:20 PM |
| School CNC Mill | dpbarry | General CNC (Mill and Lathe) Control Software (NC) | 3 | 03-06-2006 06:41 PM |
| | |
Linear Mode
