What is this called and where can I order it? - CNCzone.com-The Largest Machinist Community on the net!

Alex_Cole · #1 01-22-2007, 03:29 PM

I have a Dyna 2400 mill that I am converting to Servo drive. I decided to strip down the machine to give it a good once over even though it looked to be in good shape. The lead screws for each axis is covered by a black rubber accordian boot to protect it from junk getting in there. On my X axis one of these boots is falling appart and I need to replace it. Does anyone know what they call this stuff or where I might be able to order it other than through Dyna?

Thanks for any help.

AC

Al_The_Man · #2 01-22-2007, 03:43 PM

Gortite http://www.gortite.com/bellows.htm
Al.

Alex_Cole · #3 01-23-2007, 05:46 AM

Thanks That is exactly what I needed.

AC

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
What are they called	Rhodan	CNCzone Club House	5	08-23-2006 12:29 AM
Blind Teeth or so they are called	pinguS	General Metalwork Discussion	1	08-02-2006 02:56 PM
What is the white plastic called?	WarrenW	Mechanical Calculations/Engineering Design	22	12-24-2005 08:39 AM
Order to purchase	CanopyFx	DIY-CNC Router Table Machines	2	05-02-2005 03:24 PM
Congratulations are in order	Turbine	CNCzone Club House	3	01-05-2004 12:48 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)