Unknow Hangzhou Westlake

[szcharle]

Hi titoniks, thx!
you pic enlight me! and i will find a steel board about 5mm thick to connect mill and motor like yours. it's really a easy solution!

[ata]

Hi titoniks,
could you show me your new acme/ball-screw, thx.

Ata

[CNCQuest]

Originally Posted by ata Yes, enough, I use to mill small piece of alu with max high only 100mm. Do you know whatfor is this? -->

If that is a West Lake Drill, the arrows indicated in your picture is for adjusting the motor mounting plate.

[nyrensv]

Originally Posted by titoniks This? Tito

I´m interrested to by a similar machine as you have on your picture.I want to know if you is satisfied with it´s performance and precission and what kind of work you doing with it.
(It was a long time ago you post it but i had to try to get an ansver anyway)

Best regards Christer