Mini Mill Motor Flange type
I have had a defekt at the motor controller of my mini-mill. It now outputs only 9V where I should have 12V. I have not yet checked it thoroughly through but a new motor controller card is 120$ + shipping to Europe...
I was thinking that for that kind of money I could get a decent VFD off eBay and put a correct three-phase AC motor on top.
As I have no access to other machines (except a drill-press ) currently and of course my mill is useless without motor, I am looking for a near to direct fitting.
So the big money question would be: what mounting format is the actual mini-mill motor? Is there a table online I could find?
I have found and checked the NEMA specs but it's obvioulsy not that type.
Any help is very welcome