| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Benchtop Machines Discuss all mini mills sherline, taig, square column, round column and CNC mill conversions here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-12-2005, 09:59 AM
| |||
| |||
 Using Dremel 3/16" Bits In My MaxNC I do a lot of shopping from www.widgetsupply.com because of their great prices and selection on carbide Dremel bits, so I wanted to use these bits in my MaxNC 10CL mill. The really small bits have a 3/16" shank, but unfortunately there is no 3/16" collet. So, I took a 5/16" roll pin (sometimes called a split pin) which has a 3/16" inside diameter and inserted it into the 5/16" collet. The roll pin acts as a sleeve to hold the bit and keeps the bit centered. Works great?     |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
