Hey Guys,

I am putting the wiring in place for my cnc conversion and will be running everything through the C11 BOB.

my questions are hoping someone has or could snap some pictures of the wiring inside the box. I want to use the tachometer still but due to the KBMM-225 being 220v, i had to remove alot of stuff inside and i had taken some pictures on my phone but as luck would have it, i lost my phone on a boating trip (long story) but anyways i no longer have those photos and the manual diagram is quite lacking because the pins on the board are not labeled as the diagram is shown.

basically just need to see how to switch on the tach using the factory 115v line in. my guess is that it simply needs a wire put on a switch but i don't know which terminals to jumper to make that switch happen.

any help is greatly appreciated!

Chris