I got my maxNC little mill up and running. I am playing with cutting aluminum.
I'm not sure on the RPM (i was told it's fixed at 10k, but I'll verify tonight). The machine I think is rated for 30ipm and slower. I could be way off, but jus playing around I'm keeping it at 10ipm. The finish is a bit rough but then again I have no idea what I'm doing
Can someone recommend some end mills. I see so much back and forth on how many flutes, what coatings etc etc.
I know I will break some so I don't want top of the line but something budget friendly that can do a good finish so I can see some progress.
Going to get some in 1/16, 1/8, 3/16 and 1/8.
Also any place you can recommend for learning speeds/feeds for a small little machine?
I did a drill op with the machine at 3IPM and the motor stalled.
Any help is appreciated.
thanks