Results 1 to 3 of 3

Thread: Stepper Help

  1. 02-10-2010, 10:55 PM #1
    BSawyer486
    BSawyer486 is offline
    Registered
    Join Date
    Aug 2007
    Location
    United States
    Posts
    67
    Downloads
    0
    Uploads
    0

    Cool Stepper Help

    Just a quick question. Does anyone at Keling respond to messages sent thru the website. I have tried twice in the past few months and got no response. Just curious.
    Thanks,
    Bruce

  3. 02-10-2010, 11:23 PM #2
    jalessi
    jalessi is offline
    Registered jalessi's Avatar
    Join Date
    Feb 2007
    Location
    U.S.A.
    Posts
    3277
    Downloads
    0
    Uploads
    0
    Bruce,

    You may get a much faster response calling.

    630-254-8655

    Jeff...
    Patience and perseverance have a magical effect before which difficulties disappear and obstacles vanish.

  4. 02-10-2010, 11:37 PM #3
    BSawyer486
    BSawyer486 is offline
    Registered
    Join Date
    Aug 2007
    Location
    United States
    Posts
    67
    Downloads
    0
    Uploads
    0
    Hey Jeff,
    Thanks, I'll try to give them a call, just a little pressed for time during the day at work (which is a good thing compared to a month ago).
    Bruce

« KL23H86-20-8B stepper voltage | KL-1212 is on the way! »

Similar Threads

  1. Need Help!- Power Supply for 4 Stepper Driver 32-65VDC and 4 Stepper Motor 65V 2.3A
    By guy2b1 in forum DIY CNC Router Table Machines
    Replies: 16
    Last Post: 03-08-2011, 06:50 AM
  2. Beltdrive-stepper motor-stepper motor driver
    By Georg in forum Stepper Motors and Drives
    Replies: 0
    Last Post: 10-16-2007, 05:56 PM
  3. Wanted DIY stepper driver circuit for 6 wire stepper motors
    By Colin300 in forum Australia, New Zealand Club house
    Replies: 5
    Last Post: 09-20-2007, 10:20 PM
  4. STEPPER DRIVER FAQ {Stepper/driver amp per phase match.
    By huios in forum Stepper Motors and Drives
    Replies: 0
    Last Post: 08-27-2006, 09:43 AM
  5. difference between a stepper indexer and a stepper drive
    By pcroxford in forum Stepper Motors and Drives
    Replies: 0
    Last Post: 11-02-2005, 08:35 AM

Posting Permissions



About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Recommended Links

Quick Links

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.