| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Automation Technology Products Discuss Automation Technology Products here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-24-2009, 09:00 PM
| |||
| |||
Hey guys i bought a keling servo package NEMA 34 Servo Motors 3 Axis CNC Kit to be used on a cnc plasma table and was wondering if anyone knew that the 3 PCS CA-FC5-SH-NC-6 Connector Encoder Cables are shielded enough and can handle the "electric noise" that comes from a plasma cutter. I am planning to buy a new plasma cutter that does not have high frequency starting. but does anyone encountered any problems thus far, i talked to the guy at keling and he said that some people have encountered with there plasma cutter setup but i do not know if that is because they have high frequency starting. the cables that came with the package are to short for the big table that i am building and therefore need to buy ones that are longer. thanks aaron  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- Can you extend the cables of an AC servo motor yourself? | CncForMe | Servo Motors and Drives | 9 | 02-04-2009 12:51 AM |
| Feedback for Keling products | 300magnum | Automation Technology Products | 3 | 07-10-2008 11:13 AM |
| Very short cables to Flashcut Servo motors | DonFrambach | FlashCut CNC | 2 | 03-10-2007 12:16 AM |
| Short Cables on Flashcut Servo Motors | DonFrambach | Benchtop Machines | 1 | 03-05-2007 11:15 PM |
| Servo cables | SJ781 | General Electronics Discussion | 3 | 10-31-2003 10:42 AM |
| | |
Linear Mode
