Problem Encoder mounting - CNCzone.com-The Largest Machinist Community on the net!

Jens H · #1 02-11-2009, 07:49 AM

Hi.

I have buy a Servo kit with encoder. The problem is tha the encoder mountinghole is on the same side as the motorflage and shaft-flat. When it is mount, there is onle 4-5 mm shaft. It will be better if the encoder could be mounted end the other end.
Can I dismount the motor and drill 2 new thread, and is it metric or inch? Can i destroy anything.

Please advise.

Jens

Kelinginc · #2 02-13-2009, 02:20 PM

Hi Sir
You can dismount the motor and drill 2 new holes

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Help with AB Nut mounting please	slickrick	DIY-CNC Router Table Machines	14	04-28-2008 06:01 PM
Ajax CNC encoder mounting positions	Piobaire	AjaxCNC Control Products	1	12-17-2005 05:08 PM
Mounting Your VFD.	Willyb	General Electronics Discussion	1	10-02-2005 09:49 AM
How to tell if my motor is Pulse encoder or quadrature encoder?	Darc	Servo Motors and Drives	0	07-22-2005 03:51 AM
Encoder Mounting Position?	Willyb	General Metal Working Machines	15	12-17-2004 10:51 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)