Limit switch help - CNCzone.com-The Largest Machinist Community on the net!

10-26-2008, 04:02 PM

Ranscon

Join Date: Oct 2008

Location: USA

Posts: 68

Limit switch help

permalink

I have the keling inc. package with the 4030 drivers and a c10 bob. I would like to add limit switches. Does this setup require normally open or normally closed switches? How exactly do they wire to this bob. (keling's wiring diagrams are a bit vague for me.

Also, If you happen to know, I need some stronger couplings to attach the motors to the lead screws. I'm afraid of making them too strong as I want them to be the "weak link". Mine have proven to be a little too weak. Any Ideas? How strong should they be?

Thanks, Jeff

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
limit switch- home switch	normd	CamSoft Products	1	05-16-2008 06:56 PM
limit switch and home switch setup	Runner4404spd	General Electronics Discussion	0	12-15-2005 07:58 AM
Is it possible to use the home switch as the limit switch as well?	Darc	Mach Software (ArtSoft software)	2	10-23-2005 12:50 AM
Limit Switch / Home Switch in Software	Sanghera	General Electronics Discussion	6	11-01-2004 05:58 PM

All times are GMT -5. The time now is 11:52 AM.