| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Automation Technology Products Discuss Automation Technology Products here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-09-2008, 04:59 AM
| ||||
| ||||
How do you remove the big red button, do you just give it a real good shove to get it off? E-Stop is as supplied by Kelinginc.net
__________________ Cheers, Bob http://www.ocm.com.au/wordpress/  |
|
#2
10-09-2008, 08:54 AM
| ||||
| ||||
| Not exactly sure what you're asking here, but if you are talking about removing the button to be able to mount it on the controller box, the button unscrews from the switch housing. If you're talking about resetting the switch after it's been pushed in, a quick twist to the button will allow it to pop back out again. Mark |
|
#3
10-09-2008, 03:55 PM
| ||||
| ||||
That is the one, thank you  I can mount it on it's case now.
__________________ Cheers, Bob http://www.ocm.com.au/wordpress/ |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New Machine Build- EMC2 E-stop parallel port pinout and E-stop loop | GreenLead | LinuxCNC (formerly EMC2) | 12 | 08-03-2010 12:05 PM |
| Series 1 Limit Switch - E stop - Machinetek? | kewl_cat | Bridgeport and Hardinge Mills | 3 | 05-27-2008 03:55 PM |
| Emergency Stop Switch | BOBINETTE | Hobbycnc (Products) | 0 | 12-27-2007 11:41 PM |
| pminmo BOB and NC E-Stop switch | kiltjim | General Electronics Discussion | 5 | 11-20-2007 06:57 PM |
| | |
Linear Mode
