Do you have this?
http://kelinginc.net/KL-4030.doc
http://kelinginc.net/c10.pdf
Sample wiring diagrams and manual here:
http://www.cnc4pc.com/Store/osc/prod...products_id=45
What motors and power supply are you using?
CR.
Hello I purchased a set of three 4030 drivers and a breakout board from you off of ebay. do you have a better hook up drawing for the board.
Thanks Bruce
www.wtxrcdog.com
http://wtxrcdog.blogspot.com/
Do you have this?
http://kelinginc.net/KL-4030.doc
http://kelinginc.net/c10.pdf
Sample wiring diagrams and manual here:
http://www.cnc4pc.com/Store/osc/prod...products_id=45
What motors and power supply are you using?
CR.
Hello the bob I have is not the same as the on you mentioned.
This is the item # to the Ebay auction.
120270769148
Thanks Bruce
www.wtxrcdog.com
http://wtxrcdog.blogspot.com/
Hi Bruce. Keling uses the Cnc4PC C10 breakout board. It is the exact same one pictured on ebay. Are you saying that you did NOT receive a C10?
CR.
Check this one,
http://www.kelinginc.net/KL4030WiringDiag.pdf
[SIZE="2"] Here is a link to a picture of the board I have.
Pic
Thanks Bruce[SIZE]
www.wtxrcdog.com
http://wtxrcdog.blogspot.com/
Output Pin:P1,P2,P3,P4,P5,P6,P7,P8,P9,P14,P16,P17.
Input Pin: P10,P11,P12,P13,P15.
If you have any question email me at support@kelinginc.net
I was wondering if there needs to be power to vdd and.
Thanks Bruce
Last edited by wtxrcdog; 06-25-2008 at 11:15 PM.
www.wtxrcdog.com
http://wtxrcdog.blogspot.com/