Results 1 to 1 of 1

Thread: NEW DC SERVO Controller with G320

  1. 06-08-2008, 07:32 PM #1
    Kelinginc
    Kelinginc is offline
    Registered
    Join Date
    Oct 2005
    Location
    USA
    Posts
    545
    Downloads
    0
    Uploads
    0

    NEW DC SERVO Controller with G320

    See attached picture for our new DC Servvo Controller with G320
    3 or 4 axis, 65V, 20A Power Supply, C11 Breakout board with Spindle controller, E Stop, Limit switches, 1125 oz-in Peak Servo Motor
    or check here
    http://www.kelinginc.net/CNC34ServoMotorPackage.html
    Attached Thumbnails Attached Thumbnails NEW DC SERVO Controller with G320-servocontroller2.jpg  

« Recommended PSU for a 4-axis setup? | New CNC ROuter and Engraving Machine »

Similar Threads

  1. Problem with servo controller (G320)
    By faststeve in forum Gecko Drives
    Replies: 19
    Last Post: 04-03-2007, 09:18 PM
  2. g320 48v servo will this work
    By dgalaxy in forum Gecko Drives
    Replies: 0
    Last Post: 05-29-2006, 09:10 PM
  3. Controller With G320
    By kkilst in forum Gecko Drives
    Replies: 1
    Last Post: 05-10-2006, 09:07 AM
  4. Need a G320 error/reset controller
    By kevincnc in forum Gecko Drives
    Replies: 4
    Last Post: 04-21-2005, 09:14 PM
  5. G320 and back-EMF from servo
    By rc-cellar in forum Gecko Drives
    Replies: 5
    Last Post: 02-17-2005, 10:15 PM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Recommended Links

Quick Links

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.