Keling stepping driver - CNCzone.com-The Largest Machinist Community on the net!

Mongkol · #1 05-05-2008, 08:50 AM

Hi All,
I have KL-11078 stepping driver to control hybrid stepping motor at 8 wires.( 1200 Oz-in). I would like to know the power supply for this driver. I know it use at 110 VAC but I don't know what amps is compatible with this.Pls advise.

Mongkol

Kelinginc · #2 05-13-2008, 02:51 PM

if you wire the motor as Bipolar Paralle, the rated Current is 6A, So you can set at 6A in your driver by DIP switch

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Keling 5056 driver setup	alexccmeister	Automation Technology Products	9	04-19-2011 11:28 PM
as anybody bought the keling 6050 driver here	ataxy	Automation Technology Products	3	01-31-2008 11:57 AM
Keling 5056 Driver Error HELP	Cartierusm	Automation Technology Products	6	12-19-2007 10:54 PM
80V 6A Micro stepping Motor driver	eded59	Stepper Motors and Drives	0	07-30-2007 10:43 PM
Keling driver 8078	chicobee	Stepper Motors and Drives	1	06-08-2007 02:36 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)