Keling 640oz for Z-Axis - CNCzone.com-The Largest Machinist Community on the net!

02-19-2008, 08:04 AM

Zathras

Join Date: Aug 2005

Location: australia

Posts: 110

Keling 640oz for Z-Axis

permalink

Hi everyone,

I'm considering a NEMA34 (http://www.kelinginc.net/KL34H280-45-8B.pdf) but i'm unsure as to a power supply that's sufficient to drive it for the Z-axis of an X3.
For a driver, I have an IMS IM483I that specs say can drive 3Amps RMS (4Amp peak) @ 48V that should be ok.
The specs for the motor say 3.2A in serial mode but do I have to multiply that by 2 or not?

Mark

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Some Better Keling Documentation	vacpress	Automation Technology Products	15	03-22-2009 03:35 PM
Keling Support	kknigh	Automation Technology Products	2	01-22-2008 09:57 PM
Does Keling have ANY support?	fatal-exception	Automation Technology Products	8	01-10-2008 05:03 PM
Is anyone running a 640oz nema34 on a xylotex 4 axis?	cjdavis618	Xylotex	5	09-25-2007 02:42 PM
Keling router on E-bay	ibrich	Automation Technology Products	2	08-02-2007 10:14 PM

All times are GMT -5. The time now is 03:24 AM.