KL-4030 and 425oz-in

[rustamd]

I need help setting up switches on the drivers for these motors. Using 24V PS.

Any help would be appreciated.

[Kelinginc]

Use the table here
http://www.kelinginc.net/KL-4030.pdf
for example: you set at 2.7A, set switch at M5 =1,M6 =1,M7 =0 position

www.kelinginc.net

[rustamd]

but how do i know for which number to go for?

[Kelinginc]

If you hold the driver side, it marked. Sw1 is on left side

[rustamd]

i meant for which setting to go for 2.4, 2.7 and so on? How do i know which is best for me? Also there are 8 switches, but only 6 are on legend?

[rustamd]

Also, are the connectors on motors meant to pull out or no? Better to know before i try to do it...

[DennisCNC]

Just pull on them you will know

[rustamd]

Originally Posted by rustamd Also, are the connectors on motors meant to pull out or no? Better to know before i try to do it...

So can anyone tell me for sure before i take channel locks to these things?

[massajamesb]

no, they don't come out. Haven't learned the hard way, yet

[Smitty911]

Sorry

Smitty