C35, KL-5056D & Bardac 1600i DC drive - CNCzone.com-The Largest Machinist Community on the net!

04-12-2011, 07:38 PM

Fastest1

Join Date: Nov 2009

Location: USA

Posts: 1,515

C35, KL-5056D & Bardac 1600i DC drive

permalink

I think I can control the internal relay of my Bardac 1600i drive (link to manual http://bardac.com/pages/support/dc_p...1ph_drv_v6.pdf) with the output of the C35. This would give me spindle control but only of on or off. Will the C35 output a 0-10v signal or 4-20mA loop? Wouldnt this allow speed control thru mach? I do believe the G540 could produce this. If the C35 cant is there an additional card to interface with it?

Last edited by Fastest1; 04-13-2011 at 06:50 AM.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Help wiring 5056D	Thomasn	Automation Technology Products	6	08-18-2011 01:23 PM
Need Help!- Bardac 1600i wiring question	Fastest1	General Electronics Discussion	5	04-12-2010 01:59 PM
Clausing Lathe Conversion, direct drive or reduced drive	Marty_Escarcega	Stepper Motors and Drives	0	03-16-2010 10:43 AM
Simple, 3 Axes with Dual Drive/Motor (per axis), hardware splitter drive Interface.	kreutz	Stepper Motors and Drives	3	07-03-2008 06:57 PM
Anyone have experience with Bardac Spindle Drives?	howling60	General Electronics Discussion	3	10-28-2005 07:39 AM

All times are GMT -5. The time now is 11:47 AM.