| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Automation Technology Products Discuss Automation Technology Products here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
 
05-29-2010, 12:22 PM
| |||
| |||
Switches 1-4 connect to pins 1-4 of the processor chip... only 1-3 seem to be defined for setting the microstep values. Switches 5-7 set the drive current Switch 8 visually is not connected on the circuit board.  |
|
#3
05-29-2010, 04:18 PM
| |||
| |||
| Thanks. Obviously Switch 8 does nothing, if it is not connected. Any one know what switch 4 does? (my original post should have asked about dips 4 and 8, not 5.) I understand setting the stepping and current. But have never seen anything that says what the other 2 switches do. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 3 NEW KELING-4030 MICROSTEP DRIVERS | heilcnc | EBAY ADS | 0 | 10-01-2009 08:33 PM |
| 3 NEW KELING-4030 MICROSTEP DRIVERS | heilcnc | EBAY ADS | 0 | 09-28-2009 06:54 PM |
| Keling 4030 C10 Wiring help. | nlancaster | Automation Technology Products | 26 | 07-13-2009 09:38 PM |
| Need Help!- Keling 4030 losing steps? | jonmessenger | Automation Technology Products | 3 | 09-28-2008 12:21 PM |
| Microstepping drive-alternative to Keling KL-4030? | jakovn | Stepper Motors and Drives | 2 | 08-27-2008 05:41 PM |
| | |
Linear Mode
