Yet another C10 and KL4030 setup question

[tomk358]

Total newbie. Just got a set of 4030s, C10BOB and 36v PSU.
I wired it up to test with 1 stepper, and am not able to jog from mach3.

The motor is locked when power is on, so I'm assuming it's powered up properly. I set up mach3 pins as per the keling webpage, but I get no motion on jog.

Is there any way to hook up a volt meter to test if it's the C10 BOB, the parallel cable, or the mach3 setup?

-Tom

[tomk358]

Figured it out.

Turns out if I'm running firefox at the same time as mach3, then jog doesn't work. Not sure why. If I quit firefox, then it works again.

-Tom