| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Automation Technology Products Discuss Automation Technology Products here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-24-2010, 08:03 PM
| |||
| |||
Total newbie. Just got a set of 4030s, C10BOB and 36v PSU. I wired it up to test with 1 stepper, and am not able to jog from mach3. The motor is locked when power is on, so I'm assuming it's powered up properly. I set up mach3 pins as per the keling webpage, but I get no motion on jog. Is there any way to hook up a volt meter to test if it's the C10 BOB, the parallel cable, or the mach3 setup? -Tom  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| C10 with KL4030 driver wiring instruction for Newbies | csmoak25 | Automation Technology Products | 1 | 09-27-2010 02:00 PM |
| Need Help!- Wiring KL4030 with DB 25 | csmoak25 | Automation Technology Products | 11 | 03-04-2010 08:58 PM |
| Problem- Vibration/Feedback Problems - C10BOB with KL4030 drivers and KL23H286 motors | ehcnc627 | Automation Technology Products | 3 | 01-22-2010 03:52 PM |
| Anyone help with a setup question? | jaysteel | Machines running Mach Software | 8 | 02-05-2009 10:18 PM |
| No motion from project using KL4030 driver | Delanoman | Machine Problems, Solutions , Wireless DNC, serial port | 9 | 02-01-2009 11:38 PM |
| | |
Linear Mode
