| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Automation Technology Products Discuss Automation Technology Products here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-18-2010, 12:40 AM
| |||
| |||
I have 3 the same sets (IMT 901 is the same as TA8435HQ). In Bipolar series I can only pulse up to 3200 HZ ( about 16 rev/sec) and in Bipolar parallel 5000HZ or 20 rev sec. After that the motors rumble and stall. Run absolutley sweetly at about 2800HZ. Several other things noted, they draw about 1.8Amps when stopped and about 0.26 when running uncoupled, still the same problem. Can anyone tell me why this may be happening? Tried adjusting voltage in from 13 to 22V, almost no difference  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem- Vibration/Feedback Problems - C10BOB with KL4030 drivers and KL23H286 motors | ehcnc627 | Automation Technology Products | 3 | 01-22-2010 03:52 PM |
| Thinking of Converting my Mill's Anilam Controller to a Larken Based Controller.. | CNC-Joe | Larken | 4 | 11-06-2009 11:03 PM |
| Newbie- Warming problem with motors KL23H286-20-8B | htman7 | Automation Technology Products | 10 | 10-15-2009 06:14 AM |
| DX-32 Controller | hilljk46052 | Bridgeport and Hardinge Mills | 5 | 08-09-2007 09:48 AM |
| DeskCNC 2nd. gen controller AND HobbyCNC Pro Controller | maycom | DeskCNC Controller Board | 1 | 06-02-2007 01:33 PM |
| | |
Linear Mode
