How can I wire a 5th axis on the c10 breakout board
How can the c10 breakout board be wired for a 5th axis and can Mach3 run it?
Thanks!
Similar Threads:
- Need a bit of help with the KL-DB25RS 6 axis breakout board
- Need Help!- 5 axis breakout board and 3 single axis drivers tb6560, not working
- Need Help!- 4 Axis Breakout Board Help
- 5 axis breakout, TB6560 driver, 6 wire stepper
- New Machine Build- How to wire my motors power supply and controllers with breakout board
Yes and yes, configure C10 pins 16 & 17 for B-axis.Originally Posted by 3Dsigns
See link below for a six axis screen set if you do not want to design your own.
This thread explains more in detail.
New (revised) Mach3 6-axis screen
Hope this helps,
Jeff...
Last edited by jalessi; 10-17-2013 at 08:47 PM. Reason: Added updated link & additional information.
Patience and perseverance have a magical effect before which difficulties disappear and obstacles vanish.
Thanks Jeff!
Would this be right.......
PUL- to 16
DIR- to 17
PUL+ to GND ??
Thanks
Posting Permissions
Reply with Quote