MDT 6 Surface Cut - CNCzone.com-The Largest Machinist Community on the net!

04-10-2007, 10:56 PM

djzepp

Join Date: Nov 2006

Location: Australia

Posts: 3

MDT 6 Surface Cut

permalink

Hi Guys

I'm trying to do a surface cut to a part with a surface I created from exploding a imported part.My surface has 4 logical boundaries,is a single surface and contains no sharp corners. I'm not very familiar with this process but I have preformed it once previously.My problem is that every time I try I get a Error: Face not owned by owner. Mechanical Desktop Help doesn't offer much help.

Thanks

Dave.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Surface finish	d.a.v.e	Mechanical Calculations/Engineering Design	1	11-10-2006 01:35 PM
Helix around surface	id 10 t	Rhino 3D	3	07-25-2006 04:31 AM
32 surface finish	mroy0404	General Metalwork Discussion	4	05-28-2006 09:02 PM
could you check my surface.	corrie	Rhino 3D	12	04-08-2006 08:35 PM
3D wireframe surface	JW Peters	Autodesk Software (Autocad, Inventor etc)	3	05-09-2005 07:23 PM

All times are GMT -5. The time now is 03:55 PM.