INVENTOR 2010 help - CNCzone.com-The Largest Machinist Community on the net!

larry53 · #1 09-05-2010, 11:16 AM

I am having trouble with I extrude a hole or center point in a model. It leaves a what appears to be a strip in the middle. I have tried several things but no matter what I have tried there is always a strip left in the middle.

lostmyed · #2 09-09-2010, 07:32 AM

Upload the file Harry and i will take a look for you. Just 1 thought are you sure the strip is not just a glitch from your graphics card? Some (non-certified) cards produce strange anomalies on the screen.

larry53 · #3 09-09-2010, 11:24 AM

I found a error in the drawing. It is fine now. thanks for the input.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Got Inventor 2010 today.	single phase	Hypermill	16	06-20-2010 10:19 PM
edgcam 2010 and inventor 2010	inflateable	EdgeCam	8	03-22-2010 03:03 AM
Inventor 2010 and Video Cards	WOLOG	Autodesk Software (Autocad, Inventor etc)	5	02-24-2010 08:05 PM
Inventor 2010 doesn't start	elegon	Autodesk Software (Autocad, Inventor etc)	4	01-05-2010 10:39 AM
Need Help!- Inventor 2010	m98custom1212	Autodesk Software (Autocad, Inventor etc)	18	10-13-2009 09:16 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)