Fusion360 Post Processor for MACH3 Plasma

[bc201081]

I have just started using Fusion360 my question is, Is there is a Fusion360 postprocessor for Mach3 Plasma?

I'm trying to use the Waterjet/Laser/Plasma Contour in CAM but when I try to post process using the generic Mach3Mill I get this error.

"Error: Waterjet, laser, and plasma cutting toolpath is not supported by the post configuration."

Similar Threads:

• Tapping in Mach3 with Fusion360
• wanted post processor from sheet cam to mach3 and mach 4 plasma
• Fusion360 for FADAL post Processor
• Need Help!- Multiple G28 command cause Z issue in Mach3 from Fusion360
• Need Help!- post processor for mach3 plasma m03 torch on

[daniellyall]

ask on the forum you will need a custom post