Hi Guys n Gals,

I have an issue with my Femco boring mill's tool changer.
During the tool chage process (when the arm swings to put a tool in the spindle) sometimes the arm goes a bit slower than usual and when the arm
pulls in to place the tool in the spindle, it isn't in place yet and the pullnut jams into the face of the spindle.

its rare when this happens, but I was curious if there was a way to add a 1 o 1.5 sec. dwell to that TC movement in the macro to make up
for the inconsistency of the timing ?

Thanks Guys.

Similar Threads: