Request: Quotation for small Heatsink/Cooler block for Embedded Computer

[MrBean_pm]

Hello Guys,
I'm Melbourne (Australia) based, and am designing a small 3.5" Embedded Computer project.

I need to have a total silent, passive-cooled device, and have designed a small heatsink-interface piece, made out of 50mm(w) x 88mm(L)x25mm(h) aluminium.

This will connect the CPU and Northbridge on my Commell LS-373 motherboard to the "roof" of my extruded aluminium case, the donor which was an AAEON-6820 Industrial Computer.

Please find attached a screenshot, as well as AutoCAD design.

Any idea on pricing on cnc-machining this piece will be appreciated, I will need 1 right away, but am planning on ordering another few after, but likely no more than 10.

Much obliged - pricing from the USA is fine, please indicate idea on shipping to 3109, Victoria, Australia too.

This is a low-volume, private endeavour, to be implemented in Carputer use - so bear that in mind when pricing

Thank you in andvance.
Phillip aka mrbean

[FUBAR62172]

I'd like to do the job for you but the shipping will be WAY expensive

[jbo]

Hi Mr Bean

is the ob still open for quotation

JBO

[MrBean_pm]

Hello JBO,
Sorry, I have had a friend made 5 prototypes, - this job is done.

However, I have adjusted the initial design, and please feel free to quote me on that - the post is in this here!

Thank you, and sorry for my very late response - I will be more punctual with the requested job though!

Kind regards,
Phillip aka mrbean