| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-10-2008, 03:58 PM
| |||
| |||
G'Day everyone, I own a Multicam 3 axis router table (stepper). It runs a very old (98') version of toolpath. I am looking into possible upgrade to something more recent since the old version will only operate on windows 98 second edition. I contacted Multicam and was told their later software wouldn't run that machine. So, after doing some searching I noted that Mach3 can be used to run a router table with up to 6 axis. What do I need to do to convert my machine to run on Mach3? Do I need a whole new driver card for the machine? The old card that talks to the machine plugs into the very early slots (ISA) before PCI. If somebody could point me in the right direction that would be great. Regards, Chris  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bridgeport with BOSS 9 advice wanted | shovelitdeep | Bridgeport and Hardinge Mills | 6 | 05-18-2009 12:46 AM |
| Need Help!- help wanted | carlosmeza46 | Mach Wizards, Macros, & Addons | 0 | 06-22-2008 03:41 PM |
| Tooling Advice Wanted | Babba | Engraving Machines | 9 | 02-03-2008 10:38 PM |
| New and in need of some advice... well alot of advice! | GoonShoes | Bridgeport and Hardinge Mills | 9 | 05-30-2007 07:03 AM |
| Sieg X3 Z-axis Conversion advice wanted | Bird_E | General Metal Working Machines | 22 | 11-27-2005 08:06 PM |
| | |
Advice Wanted 
Linear Mode
