New in OZ teckcel-enroute

[mal mckenzie]

Hi all
I am in N.S.W. and am trying so sort a few problems with my Teckcel-enroute combo can anyone help ?
Ta Mal

[Reflow]

Howdy Mal,

Might need to be more descriptive about your problems to get an answer.
Where abouts in NSW are you? Last time I checked it covers a lot of ground

Cheers,
Scott

[mal mckenzie]

Originally Posted by Reflow Howdy Mal, Might need to be more descriptive about your problems to get an answer. Where abouts in NSW are you? Last time I checked it covers a lot of ground Cheers, Scott

Hay Scott
Where are you ?
Thanks for your reply & advise ,I am in the Port Macquarie area, we worked out the problem today it was with the show contors prefrence in the view tab , it had been ticked off ??? dont know how. We had just loaded enroute on the control computer and had this problem so we loaded enroute onto one of our office comp's and it worked fine ,so compaired the two and found the difference .

Now we are trying to figure how to delete templates ,any hints there appreciated.
Ta Mal

[Reflow]

Hey,

I'm in Sydney, unfortunately I know nothing about enroute, I figured your problems could have been more generic.

Best of luck,
Scott

[Stewey]

I'm near Toowoomba, with a Tekcel-converted router (K series2), and Enroute- I'm a beginner, but have figured out a ton of mistakes & how to get around them, so I may be able to help with ideas if you're stuck in the future!

[mal mckenzie]

Hi Stewey
Thanks for your reply ,I was just at AWISA today talking to John Roots about a tekcel up your way,I will be up there in 3 weeks would like to meet you and chew the fat.If you are interested reply and we can swap numbers.
Thanks for the offer of help if I can return the favour I will.Like you we have learnt a lot and would be happy to share.
Mal

[Stewey]

Thanks for the reply, Mal.
I'm not sure about the rules of putting phone numbers up here, but you're welcome to come over if you're up this way-(edited out)- or maybe I should have PM-ed you with it. We're 72 km NW of Toowoomba- email me and I'll send you a map!

We spent about a month trying to trace the answers to problems we were having-with a 2nd hand machine. Ultimately, our problems were a couple of tiny short-circuits in weird places, and poor contact in some ribbon-cable at the servo, plus a crook limit-switch. The router works beautifully now. John Roots was a GREAT help.

When you say you want to delete a template, do you mean you want to delete a plate you have defined, or some other template? (& which version of Enroute do you use?)