Results 1 to 4 of 4

Thread: Stepper motors

  1. #1
    Registered robbycar's Avatar
    Join Date
    Apr 2004
    Location
    Australia
    Posts
    5
    Downloads
    0
    Uploads
    0

    Stepper motors

    Hi Guys,

    I am in Sydney, and currently trying to convert a Hafco RF-25 drill mill to CNC.

    I have the controller and software, but I need to get a hold of the steppers.

    Can anyone point me in the right direction where I can get these?

    Rob.


  2. #2
    Registered
    Join Date
    Jul 2003
    Location
    Australia
    Posts
    322
    Downloads
    0
    Uploads
    0
    Hi Rob,

    My suggestion is "ebay". I bought 11 from there a while back and about 6 were very good.
    You might have some better luck, search under CNC and Stepper Motor.
    It is quite hard to find surplus steppers.
    I also found some steppers in a forum and he happened to be a local guy. I went to his house and got them really cheap, $20 per unit, about 100oz


  3. #3
    Registered Kookaburra's Avatar
    Join Date
    Apr 2003
    Location
    Australia
    Posts
    372
    Downloads
    0
    Uploads
    0
    Robby,

    About surplus motors, PM me, I might be able to help.
    "A Helicopter Hovers Above The Ground, Kind Of Like A Brick Doesn't"
    Greetings From Down Under
    Dave Drain
    Akela Australia Pty. Ltd.

    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)


  4. #4
    *Registered User*
    Join Date
    Feb 2004
    Location
    Christchurch New Zealand
    Posts
    9
    Downloads
    0
    Uploads
    0
    New one? - try www.nanotec.com . I got them to NZ by mail directly from nanotec and I am very happy
    witold


Similar Threads

  1. Does anyone know of a controller board for synchronized stepper motors
    By Yellowbeard in forum Stepper Motors and Drives
    Replies: 2
    Last Post: 04-04-2005, 12:06 AM
  2. Looking for controller board for synchronized stepper motors
    By Yellowbeard in forum General Electronics Discussion
    Replies: 0
    Last Post: 04-02-2005, 09:50 AM
  3. Stepper Motors
    By kellogs72 in forum Stepper Motors and Drives
    Replies: 1
    Last Post: 11-29-2004, 08:27 PM
  4. Stepper motors...
    By Mikael in forum Stepper Motors and Drives
    Replies: 4
    Last Post: 09-14-2004, 05:41 PM
  5. disassembly of stepper motors
    By dhprc2 in forum General Electronics Discussion
    Replies: 8
    Last Post: 06-25-2003, 08:09 PM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.